Refer to the exhibit.
An engineer is configuring router R1 for OSPFv3 as shown. Which additional configuration must be performed so that the three active interfaces on the router will advertise routes and participate in OSPF IPv6 processes?

Afrom 2.2.2.2, with a TTL of less than 2

Bto 2.2.2.2, with a TTL of less than 253

Cfrom 2.2.2.2, with a TTL of 253 or more

Dto 2.2.2.2, with a TTL of 2 or more

1 answers

94 votes

1338

Answer Link

A network engineer Is implementing a QoS policy for outbound management traffic classification and marking on a CPE device with these requirements:
A network engineer Is implementing a QoS policy for outbound management traffic classification and marking on a CPE device with these requirements
* Management protocols must be marked with DSCP AF class 2 w4h low drop probability.
* Monitoring protocols must be marked with DSCP AF class 1 with low drop probability.
* All remaining traffic must be marked with a DSCP value of 0.
Which configuration must the engineer implement to satisfy the requirements?
A)
B)
C)
D)

AOption A

BOption B

COption C

DOption D
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus1000/sw/4_0/qos/configuration/guide/nexus1000v_qos/qos_6dscp_val.pdf

1 answers

72 votes

1022

Answer Link

A customer of an ISP requests support to setup a BGP routing policy. Which BGP attribute should be configured to choose specific BGP speakers as preferred exit points for the customer AS?

Ahighest local preference outbound

Blowest local preference inbound

Chighest local preference inbound

Dlowest multi-exit discriminator

1 answers

77 votes

1158

Answer Link

Which two uses of the YANG data modeling language are true? (Choose two)

AIt can be used to shape slats data of network elements

BIt can be used to access a device by HTTP

CIt can be used to model the configuration used by NETCONF operations

DIt can be used to replace the OSI model for troubleshooting

EIt can be used to replace RESTCONF as a mechanism to install and manipulate configuration

1 answers

72 votes

1433

A, B

Answer Link

An engineer is setting up overlapping VPNs to allow VRF ABC and XYZ to communicate with VRF CENTRAL but wants to make sure that VRF ABC and XYZ cannot communicate. Which configuration accomplishes these objectives?
A)
B)
C)

AOption A

BOption B

COption C

1 answers

83 votes

1311

Answer Link

Cisco 350-501 Quiz:4 Topic:6 Questions:16-20

Free Practice Mock Questions Set 16-20 (Quiz # 4) for Cisco 350-501 Exam, according to official Cisco Implementing and Operating Cisco Service Provider Network Core Technologies exam syllabus topic # 6

Quiz 1

Quiz 2

Quiz 3

Quiz 4

Quiz 5

Quiz 6

Quiz 7

Quiz 8

Refer to the exhibit.An engineer is configuring router R1 for OSPFv3 as shown. Which additional configuration must be performed so that the three active interfaces on the router will advertise routes and participate in OSPF IPv6 processes?

A customer of an ISP requests support to setup a BGP routing policy. Which BGP attribute should be configured to choose specific BGP speakers as preferred exit points for the customer AS?

Which two uses of the YANG data modeling language are true? (Choose two)

An engineer is setting up overlapping VPNs to allow VRF ABC and XYZ to communicate with VRF CENTRAL but wants to make sure that VRF ABC and XYZ cannot communicate. Which configuration accomplishes these objectives?A)B)C)

Cisco 350-501 Quiz:4 Topic:6 Questions:16-20

Refer to the exhibit.
An engineer is configuring router R1 for OSPFv3 as shown. Which additional configuration must be performed so that the three active interfaces on the router will advertise routes and participate in OSPF IPv6 processes?

An engineer is setting up overlapping VPNs to allow VRF ABC and XYZ to communicate with VRF CENTRAL but wants to make sure that VRF ABC and XYZ cannot communicate. Which configuration accomplishes these objectives?
A)
B)
C)