Cisco 350-501 Quiz 6 Topic 3 Questions 26-30

Question: 1

A network engineer must enable the helper router to terminate the OSPF graceful restart process if it detects any changes in the LSA. Which command enables this feature?

Ansf ietf helper disable

Bnsf cisco enforce global

Cnsf ietf helper strict-lsa-checking

Dnsf Cisco helper disable

Show Answer

Question: 2

Why do Cisco MPLS TE tunnels require a link-state routing protocol'?

ALink-state routing protocols use SPF calculations that the tunnel endpoints leverage to implement the tunnel

BThe link-state database provides a data repository from which the tunnel endpoints can dynamically select a source ID

CThe tunnel endpoints can use the link-state database to evaluate the entire topology and determine the best path

DThe link state database provides segmentation by area, which improves the path-selection process

Show Answer

Question: 3

You are writing an RPL scnpt to accept routes only from certain autonomous systems Consider this code.

q3_350-501

If you apply this code to BGP filters, which effect does the code have on your router?

Adenies routes from AS 7070

Ballows routes from AS 7077

Cdenies routes from AS 7007

Dallows routes from AS 770

Show Answer

Question: 4

A customer of an ISP requests support to preferred exit points for the customer AS?

Ahighest local preference outbound

Blowest local preference inbound

Chighest local preference inbound

Dlowest multi-exit discriminator

Show Answer

Question: 5

Refer to the exhibit:

q5_350-501

AThe router uses NSF to load balance traffic between two links, with the primary link alternating every 90 seconds

BThe router uses NSF to reduce neighbor-relationship downtime during RP switchover

CThe router uses NSF to load balance traffic on a routed EtherChannel

DThe router uses NSF to handle RP switchover while allowing neighbor relationships to remain up

Show Answer

Cisco 350-501 Quiz:6 Topic:3 Questions:26-30