Cisco 350-501 Quiz 9 Topic 8 Questions 41-45

Question: 1

Refer to the exhibit.

q1_350-501

An engineer implemented this configuration. What is the status of the neighbor relationship between R1 and R2?

AThe neighbor relationship is up because R2 is level i and level 2 router.

BThe neighbor relationship is down because the two routers are configured with different area types.

CThe neighbor relationship is down because the two routers are in the same subnet.

DThe neighbor relationship is down because R2 is operating as a Level 1 router and the two routers are in different areas.

Show Answer

Question: 2

A network engineer is deploying VPLS configuration between multiple PE routers so that customer's remote offices have end-to-end LAN connectivity. Which additional configuration should the engineer perform on the PE routers to enable the virtual switch instance?

A)

q2_350-501

B)

q2_350-501

C)

q2_350-501

D)

q2_350-501

AOption A

BOption B

COption C

DOption D
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_l2_vpns/configuration/xe-3s/mp-l2-vpns-xe-3s-book/mp-vpls.html#GUID-D5B09E97-F785-4BCD-91F7-8E7C7E5F5A04

Show Answer

Question: 3

Refer to the exhibit.

q3_350-501

An engineer is preparing to implement data plane security configuration. What is the effect of this configuration?

AAll traffic to 192.1W1.024 is dropped.

BAll traffic dropped.

CRouter 1 drops all traffic with a local-preference set to 150.

DRouter 1 and Router 2 advertise the route to 1920 2.0 24 to all BGP peers.

Show Answer

Question: 4

Refer to the exhibit.

q4_350-501

A network engineer is implementing an OSPF configuration. What is the output of this implementation?

AIn the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.

BOSPFv3 does not run for IPv4 on FastEthernetO'O until IPv61 routing is enabled on the router and IPv6 Is enabled on interface FastEthernet0/0.

CIPv6 routing not enabled' Is just an Informational message and OSPFv3 runs for IPv4 on interface FastEihernet0/0 anyway.

DOSPFv3 cannot be configured for IPv4. OSPFv3 works only for IPv6.

Show Answer

Question: 5

Refer to the exhibit.

q5_350-501

An engineer is implementing BGP selective prefix suppression. The router must advertise only 10.16.4.0/24,10.16.5.0/24. and summarized route 10.16.0.0/21. and suppress 10.16.6.0/24. Which configuration must the engineer apply to the router?

A)

q5_350-501

B)

q5_350-501

C)

q5_350-501

D)

q5_350-501

AOption

BOption

COption

DOption

Show Answer

Cisco 350-501 Quiz:9 Topic:8 Questions:41-45