Cisco 350-401 Quiz 56 Topic 4 Questions 276-280

Question: 1

What Is the difference between the MAC address table and TCAM?

AThe MAC address table supports partial matches. TCAM requires an exact match.

BThe MAC address table is contained in TCAM ACL and QoS information is stored in CAM.

CRouter prefix lookups happen in TCAM. MAC address table lookups happen In CAM.

DTCAM is used to make L2 forwarding decisions. CAM is used to build routing tables

Show Answer

Question: 2

Refer to the exhibit.

q2_350-401

Refer to the exhibit. An engineer must configure an ERSPAN tunnel that mirrors traffic from linux1 on Switch1 to Linux2 on Switch2. Which command must be added to the destination configuration to enable the ERSPAN tunnel?

A(config-mon-erspan-dst-src)# origin ip address 172.16.10.10

B(config-mon-erspan-dst-src)# erspan-id 172.16.10.10

C(config-mon-erspan-dst-src)# no shut

D(config-mon-erspan-dst-src)# erspan-id 110

Show Answer

Question: 3

Refer to the exhibit.

q3_350-401

An engineer attempts to bundle interface Gi0/0 into the port channel, but it does not function as expected. Which action resolves the issue?

AConfigure channel-group 1 mode active on interface Gi0/0.

BConfigure no shutdown on interface Gi0/0

CEnable fast LACP PDUs on interface Gi0/0.

DSet LACP max-bundle to 2 on interface Port-channeM

Show Answer

Question: 4

Refer to the exhibit.

q4_350-401

An engineer configures a new WLAN that will be used for secure communications; however, wireless clients report that they are able to communicate with each other. Which action resolves this issue?

AEnable Client Exclusions.

BDisable Aironet IE

CEnable Wi-Fi Direct Client Policy

DEnable P2P Blocking.

Show Answer

Question: 5

Refer to the exhibit.

q5_350-401

Refer to the exhibit. A network engineer configures a GRE tunnel and enters the show Interface tunnel command. What does the output confirm about the configuration?

AThe keepalive value is modified from the default value.

BInterface tracking is configured.

CThe tunnel mode is set to the default.

DThe physical interface MTU is 1476 bytes.

Show Answer

Cisco 350-401 Quiz:56 Topic:4 Questions:276-280