Cisco 200-301 Quiz 13 Topic 5 Questions 61-65

Question: 1

I 1

Which two command sequences must be configured on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (Choose two)

Ainterface GigabitEthernet0/0/1
channel-group 10 mode on

Binterface GigabitEthernet0/0/1
channel-group 10 mode active

Cinterface GigabitEthernet0/0/1
channel-group 10 mode auto

Dinterface port-channel 10
switchport
switchport mode trunk

Einterface port-channel 10
no switchport
ip address 172.16.0.1.255.255.255.0

Show Answer

Question: 2

What are two similarities between UTP Cat 5e and Cat 6a cabling' (Choose two.)

ABoth operate at a frequency of 500 MHz.

BBoth support runs of up to 55 meters.

CBoth support runs of up to 100 meters.

DBoth support speeds of at least 1 Gigabit.

EBoth support speeds up to 10 Gigabit.

Show Answer

Question: 3

Refer to the exhibit. An access-list is required to permit traffic from any host on interface GiO/O and deny traffic from interface GiO/i. Which access list must be applied?

q3_200-301

AOption A

BOption B

COption C

DOption D

Show Answer

Question: 4

In QoS. which prioritization method is appropriate for interactive voice and video?

Aexpedited forwarding

Btraffic policing

Cround-robin scheduling

Dlow-latency queuing

Show Answer

Question: 5

A user configured OSPF in a single area between two routers A serial interface connecting R1 and R2 is running encapsulation PPP By default, which OSPF network type is seen on this interface when the user types show Ip ospf interface en R1 or R2?

Aport-to-multipoint

Bbroadcast

Cpoint-to-point

Dnonbroadcast

Show Answer

Cisco 200-301 Quiz:13 Topic:5 Questions:61-65