Cisco 200-301 Quiz 8 Topic 4 Questions 36-40

Question: 1

When a WLAN with WPA2 PSK is configured in the Wireless LAN Controller GUI, which format is supported?

AUnicode

Bbase64

Cdecimal

DASCII

Show Answer

Question: 2

What are two reasons for an engineer to configure a floating static route? (Choose two.)

Ato automatically route traffic on a secondary path when the primary path goes down

Bto route traffic differently based on the source IP of the packet

Cto enable fallback static routing when the dynamic routing protocol fails

Dto support load balancing via static routing

Eto control the return path of traffic that is sent from the router

Show Answer

Question: 3

Which two capabilities of Cisco DNA Center make it more extensible as compared to traditional campus device management? (Choose two.)

Aadapters that support all families of Cisco IOS software

BSDKs that support interaction with third-party network equipment

Ccustomized versions for small, medium, and large enterprises

DREST APIs that allow for external applications to interact natively with Cisco DNA Center

Emodular design that is upgradable as needed

Show Answer

Question: 4

Which event has occurred if a router sends a notice level message to a syslog server?

AA TCP connection has been torn down

BAn ICMP connection has been built

CAn interface line has changed status

DA certificate has expired.

Show Answer

Question: 5

Refer to the exhibit. An extended ACL has been configured and applied to router R2. The configuration failed to work as intended. Which two changes stop outbound traffic on TCP ports 25 and 80 to 10.0.20.0/26 from the 10.0.10.0/26 subnet while still allowing all other traffic? (Choose two.)

AAdd a 'permit ip any any' statement to the begining of ACL 101 for allowed traffic.

BAdd a 'permit ip any any' statement at the end of ACL 101 for allowed traffic

CThe source and destination IPs must be swapped in ACL 101

DThe ACL must be configured the Gi0/2 interface inbound on R1

EThe ACL must be moved to the Gi0/1 interface outbound on R2

Show Answer

Cisco 200-301 Quiz:8 Topic:4 Questions:36-40