Cisco 350-501 Quiz 17 Topic 16 Questions 81-85

Question: 1

A network engineer is configuring RIP as the routing protocol between multiple PEs and CEs. The engineer must avoid advertising the same routes back to their sources. Which action should be performed on the routers to accomplish this task?

AConfigure a different route distinguisher for each prefix.

BDefine the site of origin on each interface.

CDefine VRFs on each device to separate the traffic.

DEnable bidirectional forwarding detection on each device.

Show Answer

Question: 2

Which module refers to the network automation using Ansible?

Athe iosxr_system module to collect facts from remote devices

Bthe iosxr_user module to manage banners for users in the local database

Cthe losxr_logging module to run debugging for seventy levels 2 to 5

Dthe iosxr_command module to issue run commands on remote devices

Show Answer

Question: 3

A network engineer must enable the helper router to terminate the OSPF graceful restart process if it detects any change in the LS

AWhich command enables this feature?

Show Answer

Question: 4

Refer to the exhibit.

q4_350-501

A network engineer is implementing a standard customer route-policy on router ASBR1 with these requirements:

* it must accept only customer-assigned prefixes.

* It must preserve customer-advertised BGP communities.

* it must set the local-preference to no for all prefixes.

* it must attach the ORIGINATION-PE and LOCAL-CITY communities to an accepted prefixes.

Which route policy must the engineer implement on ASBR1 to satisfy the requirements?

A)

q4_350-501

B)

q4_350-501

C)

q4_350-501

D)

q4_350-501

AOption A

BOption B

COption C

DOption D

Show Answer

Question: 5

A regional MPLS VPN provider operates in two regions and wants to provide MPLS L3VPN service for a customer with two sites in these separate locations. The VPN provider approaches another organization to provide backbone carrier services so that the provider will connect to these two locations.

What is the next step?

AWhen edge at different regional sites are connected over the global carrier backbone, MP-eBGP must run between routers to exchange the customer VPNv4 routes.

BWhen BGP is used for both route and label exchange, the neighbor a.b.c.d send-label command is used under the address-family VPNv4 command mode.

CWhen IGP used for route exchange and LDP for label exchange, MPLS is enabled only on the VRF interface on the backbone-carrier PE side.

DWhen eBGP is used for label exchange using the send-label option. MPLS-BGP forwarding is configured under the global ABC CSC PE-to-CE interface.

Show Answer

Cisco 350-501 Quiz:17 Topic:16 Questions:81-85