VMware 5V0-31.22 Quiz 1 Topic 3 Questions 1-5

Question: 1

A VCF architect collected the following requirements when designing the expansion of a new VI Workload Domain with twenty four vSAN Ready nodes, each with a dual-port 25Gbps network interface card:

* Provide scalable high-performance networking with layer-3 termination at top-of-rack

* Protect workloads from switch/NIC/rack failure

* Provide isolation for DMZ workloads

* Provide at-least 25Gbps dedicated bandwidth to backup traffic

* Easily accept workloads on traditional VLAN-backed networks

* Fully-supported by VMware

Which three design considerations meet all of these requirements? (Choose three.)

ATwo-node Edge Cluster with ECMP

BSpine and Leaf network topology with layer-3 at Spine

CStretched Clustering

DSpine and Leaf network topology with layer-3 at top of rack

ETwo-node Edge Cluster with BFD

FCore Aggregation network topology

Show Answer

Question: 2

Which two roles are played by a Spherelet in a Tanzu-enabled VCF workload domain? (Choose two.)

AIt runs as a VIB on all Supervisor Cluster ESXi hosts configured with the vSphere Networking Stack.

BIt enables an ESXi hypervisor to act as a Kubernetes master node.

CIt enables an ESXi hypervisor to act as a Kubernetes worker node.

DIt starts and monitors vSphere pods running on the workload domain cluster

EIt communicates with the vSphere with Tanzu embedded Harbor registry.

Show Answer

Question: 3

A systems administrator is tasked with creating a new VI workload domain that will leverage either an external NFS or a VMFS on FC storage as the principal storage.

Which action is required to fulfill this requirement?

ACreate a new network pool for vMotion and vSAN networks.

BCreate a new network pool only for vMotion network.

CCreate a new network pool for vMotion, vSAN, and NFS networks.

DCreate a new network pool for vMotion and NFS networks.

Show Answer

Question: 4

Which two health checks can be performed using the SoS tool? (Choose two.)

A---password-health

B---credential-health

C---system-check

D---health-check

E---esxi-health

Show Answer

Question: 5

Which two requirements are needed to add new hosts to an existing VI workload in a VMware Cloud Foundation environment? (Choose two.)

AThe host uses the same storage type as the existing cluster hosts.

BThe host uses heterogenous hardware.

CThe host uses a minimum of four network ports.

DThe host uses the same network pool

EThe host uses only the VLAN network.

Show Answer

VMware 5V0-31.22 Quiz:1 Topic:3 Questions:1-5