Huawei H12-261 Quiz 42 Topic 6 Questions 206-210

Question: 1

The network administrator defines the following policy for traffic policing:

q1_H12-261

If the policy is applied to a router port and there is no traffic on the port for about 10 seconds, how many bytes of burst will be available for class cl for packets to be marked as green?

A256K bytes

B32K bytes

C48128 bytes

D80128 bytes

Show Answer

Question: 2

Which set of characteristics best describes Link-State routing protocols?

AFast convergence and lower CPU utilization

BHigh CPU utilization and prone to routing loops

CSlower convergence time and high CPU utilization

DFast convergence and greater CPU utilization

Show Answer

Question: 3

As shown in the following figure, the content field of an HVRP frame contains all valid user VLAN information.

q3_H12-261

ATRUE

BFALSE

Show Answer

Question: 4

Suppose you are using RIP or OSPF to deploy a network. Which of the following is true?

AIf RIPv2 is used to deploy the network, routes whose measurement values are 16 cannot be viewed in the routing table.

BRIPv2 sends route update information periodically. Therefore, when the topology changes, RIPv2 is able to calculate the new route more rapidly.

CRIPvl is a distance vector routing protocol. RIPv2 and OSPF are link-state routing protocols.

DRIP does not support authentication, while OSPF supports authentication.

Show Answer

Question: 5

uRPF checks can be performed in loose or strict mode. In tough network environments under frequent attacks, the strict uRPF check mode is recommended. In well-managed internal network environments, the loose uRPF check mode can be used to save device resources.

ATRUE

BFALSE

Show Answer

Huawei H12-261 Quiz:42 Topic:6 Questions:206-210