Huawei H12-261 Quiz 36 Topic 3 Questions 176-180

Question: 1

A network contains four Routers named Rl, R2, R3, and R4. All four routers are connected to a LAN via Ethernet interfaces. All four routers have a basic OSPF configuration of a network statement for the Ethernet network. You use display ospf peer command on Router R2. The state shown for its peer Router R3 is "2-Way" . What conclusions can you draw from this output? (Multiple Choice)

ARouter R2 is the DR or BDR.

BRouter R3 is not a DR or BDR.

CRouter R2 - Router R3 adjacency is not yet FULL.

DRouter R2 is not the DR.

ERouter R4 is the DR.

Show Answer

Question: 2

Which of the following statements is true about the database synchronization process on an IS-IS broadcast network?

q2_H12-261

AAs the DIS, R2 sends a CSNP packet periodically.

BThe interval at which R2, as the DIS, sends Hello packets is three times that of other routers.

CAs the DIS, R2 does not receive the PSNP requests from other routers.

DR1 and R3 maintain the database consistency by sending PSNP packets periodically.

Show Answer

Question: 3

The router HW1 is being configured for BGP, and the configuration will contain both IBGP and EBGP peers. Which statements regarding IBGP and EBGP neighbors are true? (Multiple Choice)

ABGP updates from an IBGP peer are propagated to other IBGP and EBGP peers.

BBGP updates from an EBGP peer are propagated to other IBGP and EBGP peers.

CIBGP peers must be directly connected; if not, the IBGP-multihop option must be configured.

DEBGP peers must be directly connected; otherwise, the EBGP-multihop option must be configured E. IBGP neighbor peering can be established using the loopback interface.

EEBGP neighbor peering must use the physical interface address to establish peering.

Show Answer

Question: 4

With regard to the File Transfer Protocol (FTP), which of the following statements is true?

AFTP always uses TCP port 20 for the data session and TCP port 21 for the control session.

BFTP always uses one TCP session for both control and data.

CIn active mode, the server uses the 'PORT' command to tell the client which port it will used to send data.

DWith passive mode FTP, both the control and data TCP sessions are initiated by the client.

EFTP always uses TCP port 21 for the data session and TCP port 20 for the control session.

Show Answer

Question: 5

Which of the following statements are true about the IPv6 over IPv4 tunnel? (Multiple Choice)

AGenerally, a tunnel interface is created when configuring a manual tunnel on the VRP platform. A Virtual-Template interface is created when configuring an automatic tunnel.

BAutomatic tunnels have many more advantages than manual tunnels. The manual tunnels will be phased out.

CA 6-to-4 automatic tunnel requires a specific IPv6 address segment. The prefix of the allocated address segment is 3ffe::/16.

DThe data encapsulation mode of all automatic tunnels is the same.

EAn ISATAP tunnel determines the destination IPv4 address based on the destination IPv6 address.

Show Answer

Huawei H12-261 Quiz:36 Topic:3 Questions:176-180