Huawei H12-211 Quiz 100 Topic 2 Questions 496-500

Question: 1

On Huawei switch, which of the following commands can be used to set port duplex mode as "auto negotiation"? (Choose two)

Aduplex negotiation auto

Bduplex auto-negotiation

Cduplex auto

Dundo duplex

Show Answer

Question: 2

The network administrator wishes to transmit data between two end stations. The network interface cards of both devices operates at 100Mbps however one supports half duplex while the other uses full duplex mode.

What will occur as a result?

AThe end stations cannot communicate.

BThe end stations can communicate, but data may be lost during transmission of large amounts of traffic.

CThe end stations will operate normally

DThe end stations can communicate, but speed is different during transmission of large amounts of traffic.

Show Answer

Question: 3

An Ethernet port can work one of three duplex modes, whereas an Optical Ethernet port only supports one single mode. Which of the following represents this mode?

AFull-duplex

BHalf-duplex

CAuto-negotiation

DSimplex

Show Answer

Question: 4

While inspecting packets in the network, a network administrator discovers a frame with the destination MAC address of 01-00-5E-A0-B1-C3. What can the administrator determine from this?

AThe MAC address is a unicast address.

BThe MAC address is a broadcast address

CThe MAC address is a multicast address.

DThe MAC address is incorrect

Show Answer

Question: 5

Which of the following mechanisms are used for flow control? (Choose three)

AAcknowledgement

BBuffering

CSource quench messages

DWindowing

Show Answer

Huawei H12-211 Quiz:100 Topic:2 Questions:496-500