Huawei H12-211 Quiz 70 Topic 12 Questions 346-350

Question: 1

On the VRP platform, which of the following commands is used to configure the Router ID of a router as

1.1.1.1?

A<Huawei>router id 1.1.1.1

B[Huawei]router id 1.1.1.1

C[Huawei]router-id 1.1.1.1

D[Huawei]router id 1.1.1.1 255.255.255.255

Show Answer

Question: 2

Which of the following OSPF versions is specific to IPv6?

AOSPFv1

BOSPFv2

COSPFv3

DOSPFv4

Show Answer

Question: 3

The administrator wishes to configure OSPF on a router in the network however the router has no loopback interface. Which value will be used as the router ID?

AThe lowest IP address of the router's active interfaces.

BThe highest IP address of the router's active interfaces.

CThe IP address of the management interface

DThe priority value of the router.

Show Answer

Question: 4

An administrator of a company supporting a large enterprise network wishes to implement OSPF on the network as opposed to RIP. Which of the following points should the administrator use to support his reasoning for this change? (Choose three)

AOSPF has no hop count limitation

BOSPF has a lower routing update overhead

COSPF has a simpler configuration.

DOSPF supports faster convergence.

Show Answer

Question: 5

Which of the following statements regarding single area OSPF are correct? (Choose three)

AAn IP address needs to be configured on a loopback interface of each router before configuring an OSPF area.

BThe value of an area can be from 0.0.0.0 to 255.255.255.255.

CA single area can be configured using any supported area number.

DAll of the links of the network need to be advertised in Area 0.

Show Answer

Huawei H12-211 Quiz:70 Topic:12 Questions:346-350