HP HPE0-S60 Quiz 1 Topic 9 Questions 1-5

Question: 1

Refer to the exhibit.

q1_HPE0-S60

Which statement about this logical JBOD is true?

AThis logical JBOD can be connected to multiple systems to formulate a snared datastore.

BAfter deleting this logical JBOD drives will he blocked for 12h m case this JBOD must be re-created

CAfter deleting this logical JBOD, its drives w not be available until a clean-up procedure 6 done

DThis logical JBOD can be presented to the compute nodes in a different frame.

Show Answer

Question: 2

Your customer has a logical enclosure configured using a angle HPE Synergy frame with the following configuration

- two HPE Virtual Connect SE 100Gb F32 Modules for Synergy

- two HPE Synergy Virtual Connect SE 32Gb FC Modules -12 HPE Synergy 480 Gen10 Plus compute nodes with appropriate mezzanine cards

They plan to add a new HPE Synergy frame to an existing logical enclosure with the following configuration

- two HPE Synergy Virtual Connect SE 32Gb FC Modules

- two HPE Synergy 20Gb interconnect Link Modules

- Eight HPE Synergy 480 Gen 10 Plus compute nodes with appropriate mezzanine cards

Which statement about the planned configuration change is true?

AFour compute modules must be moved to the second frame to balance the configuration

BThe two HPE Synergy 20Gb interconnect Link Modules must be replace with the 50Gb option

CA license for an extended logical enclosure must be added to HPE OneView through GUI

DThe HPE Synergy virtual Connect SE 32Gb FC Modules from both frames should be stacked

Show Answer

Question: 3

Which statement about manual orchestration during the firmware update is true?

AIt is supported only for logical enclosures with at least three frames

BIt provides an ability to select and update one side of the Interconnect topology at a time

CIt provides the ability to install an older firmware version than currently Installed In the interconnect

DIt allows all the interconnect modules to be activated manually at the same time.

Show Answer

Question: 4

Your customer has an HPE Synergy platform deployed and managed using HPE OneView. The customer also has HPE Superdome Flex with RMC deployed They plan to deploy a second nPar and HPE Superdome Flex 280 They plan to manage new components using HPE OneView

What must be done to achieve this goal?

AThe customer must use IL05 to add HPE Superdome Flex systems to HPE OneView

BThe customer should deploy an HPE OneView appliance for HPE Superdome Flex management

CThe customer must add a second Rack Management Controller for HPE Superdome Flex 280

DThe customer has to add HPE Superdome Flex to the HPE OneView used to manage HPE Synergy

Show Answer

Question: 5

Your customer has experience with utilization sampling for HPE Virtual Connect SE 100 Gb F32 Module for HPE Synergy. They have recently purchased HPE VC FC modules.

What must you be aware of regarding utilization sampling for the new modules?

AUtilization sampling for HPE VC FC modules must be enabled manually using CLI.

BFor HPE VC FC modules, utilization sampling is always enabled and cannot be disabled

CFor HPE VC FC modules, utilization sampling can be enabled once appropriate license is applied

DUtilization sampling works the same way tor any type of HPE Synergy interconnect modules

Show Answer

HP HPE0-S60 Quiz:1 Topic:9 Questions:1-5