Cisco 300-615 Quiz 4 Topic 11 Questions 16-20

Question: 1

A mission-critical server is connected to site

AConnectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Nexus 7000 in site B due to MAC aging. Which action allows the flooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?

AUse route-map to advertise this MAC statically and redistribute with ISIS.

BUnknown unicast flooding is not allowed.

CUse the otv flood mac <> command to selectively flood traffic for a given MAC.

DUse the otv isis bfd <> command to configure BFD protocol.

Show Answer

Question: 2

Refer to the exhibit. An engineer discovered a VFC interface in a down state on a Cisco Nexus Switch. Which action resolves the problem?

AChange the cable between the switch and the server

BReset the Cisco Nexus port toward the file server

CUpdate the CNA firmware and driver versions

DModify the fip keepalive message time to 30 seconds

Show Answer

Question: 3

An engineer must replace a failed memory on a Cisco UCS B-Series Blade Server. After the replacement was done, the server has a ''resolve slot'' warning. Which server maintenance action resolves the issue?

APerform diagnostic interrupt on the server.

BRe-acknowlegement the server.

CReset the server.

DDecomission the server.

Show Answer

Question: 4

Refer to the exhibits. An engineer is implementing the SAN based on the Cisco MDS 9000 Series Switches. When operating the environment, the engineer encounters the error shown. Which action resolves the issue?

ACopy VSAN 101 to the fabric binding database on the MDS-1 switch

BAdd the World Wide Name of the neighboring switch to the MDS-1 switch

CConfigure the port security feature on the MDS-1 switch

DEnable VSAN 101 on the peer MDS 2 switch fabric interconnect

Show Answer

Question: 5

Refer to the exhibits.

q5_300-615

An engineer troubleshoots switch N5K1, which fails to receive traffic from the file server Which set of actions resolves this problem?

ABind native VLAN 10 with Ethemet1/10 and allow VSAN 101 in trunk configuration.

BAssign native VLAN 10 with vfc111 and allow VLAN 1101 in trunk configuration.

CBind native VLAN 10 with Ethemet10/1/1 and allow VLAN 10 in trunk configuration

DAssign native VLAN 10 with fc2.'l - 2 and allow VLAN 10 in trunk configuration.

Show Answer

Cisco 300-615 Quiz:4 Topic:11 Questions:16-20