Cisco 300-425 Quiz 2 Topic 12 Questions 6-10

Question: 1

An engineer is designing a new wireless network. The network needs to meet these requirements

* support a high wireless client concentration

* support data over wireless

* support voice over wireless

* avoid interference

Which design approach should be taken?

A5 GHz frequency band with channel bonding, to support 40 MHz channels

B5 GHz frequency band without channel bonding, to support 20 MHz channels

C5 GHz frequency band with channel bonding, to support 80 MHz channels

D2.4 GHz frequency band without channel bonding to support 20 MHz channels

Show Answer

Question: 2

An engineer is using a Cisco AIR-2702i AP lo conduct a Layer l site survey. Which mode is selected for the AP to discover non Wi-Fi interference with Metageek Chanaryzer?

ASniffer

BFlexConnect

CMonitor

DSE-Connect

Show Answer

Question: 3

A network engineer is designing a new wireless network. The network needs to have these characteristics:

* support high client concentration

* optimize client performance

* avoid interference

Which approach should be taken?

ADeploy APs near each other for 5 GHz coverage, and disable the 2 4 GHz radios for some APs

BDeploy APs near each other for 2 4 GHz coverage and disable the 5 GHz radios for all APs

CDeploy APs near each other for 5 GHz coverage, and enable me 2.4 GHz radios for all APs.

DDeploy APs near each other for 2 4 GHz coverage, and disable the 5 GHz radios for some APs

Show Answer

Question: 4

An engineer must perform an assessment of a customer LAN for a future IEEE 802.llac Wave 2 wireless deployment. All access switches are Fast Ethernet-capable only, and the wired infrastructure between existing APs and access switches is based on the CAT 6A standard Which two actions provide maximum support of Osco 3800 Series access points? (Choose two)

AReplace the existing switches with gigabit switches with 10 G uplinks.

BEnsure that cable distances between access switches and APs are not longer than 55 meters.

CReplace the existing wiring infrastructure with the CAT-7E wiring standard.

DReplace the existing switches with mGig switches.

EEnsure that cable distances between access switches and APs are not longer than 100 meters

Show Answer

Question: 5

An engineer has deployed a group of APs m an auditorium and notices that the APs are showing high co-channel interference Which profile is used to adjust the parameters for these high-density APs?

ARF profile

BQoS profile

CAVC profile

DISE profile

Show Answer

Cisco 300-425 Quiz:2 Topic:12 Questions:6-10